After boring and honing, the top of the bore is chamfered about 1/16". Why is this done?
What will be an ideal response?
This is so that during installation of the pistons in the block, the new rings can easily enter the cylinder without being damaged.
Trades & Technology
You might also like to view...
What three factors determine generator output voltage?
What will be an ideal response?
Trades & Technology
What part of a typical AC motor is a stationary part of the motor where the alternating current flows in and a large magnetic field is created using magnets and coiled wire?
A) Stator B) Rotor C) Bearings D) Fan
Trades & Technology
Tables and graduations that eliminate many calculations are available on the _____ square.
a. combination tri b. building c. center head d. pipefitting
Trades & Technology
Almost two-thirds of all railroad crossings in the United States are active crossings.
Answer the following statement true (T) or false (F)
Trades & Technology