While having a discussion, Technician A says that a good pattern will tend to be toward the toe of the tooth when tested under light load conditions. Technician B says that under heavier load a more complete pattern can be read across the gear tooth. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: C
You might also like to view...
This is a narrow slot formed by removing material while sawing.
a. round b. fillet c. kerf d. chamfer
The subsequent problems deal with the circuit below, where the op amp is an LM741 with an output short circuit current of 25 mA, and a maximum output voltage swing of +/? 13.6 V. NOTE: do not assume the op amp is "ideal."
The open-loop frequency response curve for the op amp, as provided by the manufacturer is:
If Vin=10V, and R=1k?, what would you expect for Vout for the real (not ideal) op amp?
A. 5 V B. 13.6 V C. 20 V D. ?20 V E. ?13.6 V
How many names appear on the title block
A. 1 B. 2 C. 3 D. 4
Hot-surface ignition units:
A) Operate for only a few minutes per day. B) Are standard ignition systems. C) Substantially increase an electric bill. D) Are powered by 220 V.