On a DC motor, the armature is typically labeled ____.

A. S1 and S2
B. F1 and F2
C. A1 and A2
D. T1 and T2


Answer: C

Trades & Technology

You might also like to view...

For the parabolic arch in Figure P6.17, plot the variation of the thrust T at support A for values of h = 12, 24, 36, 48, and 60 ft.

Trades & Technology

Which of the following materials increases the mortar's compressive strength?

A) Sand B) Lime C) Portland cement D) Mortar joint profile E) All of the above

Trades & Technology

When dimensioning a cam be sure to include:

A. degrees from the starting point B. the distance from the center C. the arc length D. both A and B

Trades & Technology

Subtract the following numbers to obtain the difference:    3,973 inches- 1,029 inches

What will be an ideal response?

Trades & Technology