Incorrect or unequal U-joint working angles are most likely to be caused by ________.

A) Defective or damaged U-joints
B) A bent drive shaft
C) A collapsed engine or transmission mount
D) A dry output shaft spline


C) A collapsed engine or transmission mount

Trades & Technology

You might also like to view...

____ backflow is a reversal of normal flow in a system caused by a negative pressure (vacuum) in the potable water supply.

a. Gravity b. Back-siphonage c. Back-pressure d. none of the above

Trades & Technology

Which fuel-injection system uses the MAP sensor as the primary sensor to determine the base pulse width?

A) Demand delivery B) Mass airflow C) Speed density D) Mechanical returnless

Trades & Technology

Technician A says brake fluid should be filled to the top of the reservoir to be assured of proper brake pressure when the brakes are applied. Technician B says that the brake fluid level should be filled only to the maximum level line to allow for expansion when the brake fluid gets hot during normal operation. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

Which of the following is indicated on a panelboard schedule?

a. GEC b. Size of wires c. Service head d. Panel mains

Trades & Technology