Technician A says that the most common use of a dial indicator is to measure the runout in a disc brake rotor. Technician B says that feeler gauges are used to measure disc brake rotor runout. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: A
You might also like to view...
The ________ provides the conductive path to connect the non-current carrying parts of equipment together.
A. Grounded Conductor B. Chassis Ground C. Equipment Grounding Conductor D. All the above
Technician A says the protective boot on a CV-joint is made of bellows-type neoprene or silicone in some cases to protect against high temperature extremes. Technician B says the boots can be made from ordinary rubber. Who is correct?
A. A only B. B only C. both A and B D. neither A nor B
A(n) ____ is used to connect a lead from a component or connect a wire from an off-board component.
A. paper doll B. jumper C. autorouter D. pad
The use of an electronic throttle control (ETC) system allows the elimination of all of these EXCEPT ________
A) Accelerator pedal B) Idle air control C) Mechanical throttle cable (most systems) D) Cruise control actuator