Which of the following methods are used to lock the bearing setting on an axle or spindle?

A. Jam nuts
B. Castellated nuts with cotter pins
C. Split forging nuts
D. All of the above


D. All of the above

Trades & Technology

You might also like to view...

A main source of heat used to warm the passenger compartment is ________.

A) Sunlight B) The vehicle engine C) Humidity D) Ambient air

Trades & Technology

While discussing manifolds, Technician A says that exhaust manifolds must carry very hot exhaust gases so they are usually made of cast iron. Technician B says that some manifolds are constructed of steel tubing. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

Reducing the CFM through the evaporator will cause the amperage draw of the compressor to ____________________.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

What fuel system component is used in a vehicle equipped with a diesel engine that is seldom used on the same vehicle when it is equipped with a gasoline engine?

A) Fuel filter B) Water-fuel separator C) Fuel return line D) Fuel supply line

Trades & Technology