FWD driveshaft problems are usually indicated by ________.
A) Noise
B) Grease from a torn boot
C) Both A and B
D) Neither A nor B
C) Both A and B
You might also like to view...
If the vector diagram of two AC waveforms is a right angle, then the waves _____.
a. are in phase b. are 90° out of phase c. have the same frequency d. have the same peak voltage
The drive pinion gear is installed with a shim that is too thick. What would this cause?
A) Incorrect backlash B) Pinion gear too far away from the ring gear C) Pinion gear too close to the ring gear D) None of these
The most commonly used process to prepare pipe for welding is the _____ torch process.?
A. ionized? B. oxy-fuel? C. plasma? D. manual?
The copper losses in the line are of two types: (1) voltage drop (IR) and (2) ____________________ loss.
Fill in the blank(s) with the appropriate word(s).