Which of the following would not be a factor when setting up an air handler's ECM motor control to deliver the correct airflow in all operating modes?
a. System cooling capacity.
b. Number of heating stages.
c. Continuous fan operation.
d. Fuel gas heat content.
d. Fuel gas heat content.
You might also like to view...
Commercial polymers range from a PI of about 2 to____.?
A. ?10 B. ?20 C. ?30 D. ?40
A torque converter is being discussed. Technician A says that the turbine provides torque input to the transmission gear set through the input shaft. Technician B says that the pump (impeller) is the driving member and the turbine is the driven member. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Approximately 71 percent of the coal used in the United States is transported by _______________
Fill in the blank(s) with the appropriate word(s).
The first oil change after an engine overhaul or replacement should occur at:
A. After the break-in test drive B. 250 miles C. 500 miles D. 1000 miles