When a print shows a circle on a slanted surface in a multiview, the angle of ellipse is ____.
A. 30° ellipse
B. 45° ellipse
C. the size that matches the degree slant of the surface
D. all of the above
E. none of the above
Answer: C
You might also like to view...
A certain type of component can be purchased new or used. Fifty percent of all new components last more than five years, but only 30% of used components last more than five years. Is it possible that the lifetimes of new components are exponentially distributed? Explain.
What will be an ideal response?
Voltage drop across a switch indicates that:
A) The switch is operating. B) The switch is closed. C) The wire to the switch is sized incorrectly. D) The switch is open.
If the evaporator is operating with a low saturation temperature and high superheat, the most likely condition is
A. an underfed evapoartor coil B. an overfed evapoartor coil C. insufficent airfow through the evaporator coil D. excessive airfow through the evaporator coil
?Which of the following statements is LEAST-Likely true?
A. ?Follow manufacturer instructions when disabling HV systems. B. ?HV systems must be disabled before performing repair work. C. ?Not properly shutting down the vehicle's electric drivetrain could be a fatal mistake. D. ?Always use a conventional 12V DVOM to try to measure hybrid drive circuit voltages.