A defective clutch release (throw out) bearing is usually heard when the clutch is ________
A) Engaged in first gear or reverse B) Engaged in neutral
C) Depressed to take up any free play D) Disengaged in gear
C
You might also like to view...
The traditionally recommended weight for selling slaughter hogs has been _____ pounds
a. 200 to 220 c. 230 to 250 b. 175 to 200 d. 150 to 175
A membrane made of 0.15-mm-thick soft rubber separates pure O2 at 1 atm and 25°C from air at 5 atm pressure. Determine the mass flow rate of O2 through the membrane per unit area and the direction of flow.
What will be an ideal response?
If you are representing the owner/engineer, and during the bidding phase of a project, a bidder telephones your office calling attention to what the bidder believes to be an error, and makes a request for clarification or correction, you should:
A. check out the reported error while still on the telephone, give the caller the corrected data orally, then send an addenda to everyone e1se . B. deny that an error exists and tell the caller to bid the work as it was specified and make his or her own interpretations. C. take all of the information from the caller, then advise him or her to bid the job as it was originally specified unless an addenda is issued, and that if an error was in fact discovered, it will be corrected by addenda which will be mailed to all bidders. D. try to be as helpful as possible by checking with the original designer; then, if an error is noted, give the caller the correct information, but do not go out of your way to inform others unless they call with the same question.
NAT stands for ________
Fill in the blank(s) with correct word