Place the steps for loading and unloading a Tubex injector in the correct order
a. Turn ribbed collar to "open" position until it stops.
b. Turn ribbed collar to "close" arrow.
c. Inject medication.
d. Insert sterile cartridge-needle unit.
e. Put on gloves.
f. Thread plunger rod into plunger of cartridge.
g. Verify physician's order.
h. Perform medical asepsis hand wash.
i. Disengage plunger rod.
j. Dispose of used equipment properly.
G, H, E, A, D, B, F, C, I, J
You might also like to view...
What building component may be an assembly of studs with exterior materials on the outside and an interior covering on the inside?
A. Wall B. Roof C. Foundation D. Floor/Ceiling
The results of platelet-rich plasma (PRP) in the aggregation studies of a patient's blood were typical of ristocetin-induced platelet agglutination (RIPA) defect. The RIPA defect was corrected by adding normal plasma to the patient's PRP
In what disease is this seen? a. Sticky platelet syndrome b. Bernard-Soulier syndrome c. Afibrinogenemia d. von Willebrand's disease
Certification for coders is mandated by HIPAA
Indicate whether this statement is true or false.
Which of the following would you include when performing a Gram stain?
A. Rub the slide to hasten drying B. Allow the stain to sit for no more than 10 seconds before rinsing C. Cover only a small area of the specimen on the side with the crystal violet stain D. Cover the entire specimen area with iodine and allow it to remain for 1 minute E. Apply exactly 3 drops of alcohol or decolorizer after rinsing away the iodine