The time constant of a capacitor is:
A) directly proportional to the capacitance in the circuit.
B) directly proportional to the resistance in the circuit.
C) the time required to charge to 63% or discharge to 37%.
D) all of these.
D
You might also like to view...
The type of bearings used in a manual transmission is ________.
A) Needle bearing B) Tapered roller bearing C) Ball bearing D) Any of these
The Percheron horse is considered which breed?
a. pleasure c. sport b. draft d. race
Answer the following statement(s) true (T) or false (F)
1.During the rough-in wiring phase, an electrician always installs cable through floors or ceilings, which provides shorter routes than do perimeter walls. 2.The electrician can incorporate waste from the rough-in and trim-out wiring phases into the jobsite-recycling system. 3.Type AC cable installed in thermal insulation must have conductors rated at 90°C (194°F). 4.Most engineered I-beams come from the manufacturer with perforated knockouts that allow an electrician to remove the knockout and install cables through the holes. 5.Type NM and Type UF cables must have their cable sheath extend into nonmetallic boxes and beyond any cable clamp at least 1/2 inch (6 mm).
Some circuit requirements may demand that the motors turn off in sequence instead of turning on in sequence. This circuit will require the use of ____ timers.
A. on-delay B. level C. automatic D. off-delay