If a power tool is found to have damage, what should be done?

A. Mark "do not use"
B. Take out of service for repair
C. Use extreme caution when operating tool
D. a and b


Answer: D

Trades & Technology

You might also like to view...

After a vehicle has been refinished, the technician notices that dirt and runs have occurred during the application of the finish. What corrective measures must the refinish technician take to prepare the vehicle for delivery?

What will be an ideal response?

Trades & Technology

For the series-parallel magnetic circuit of Figure P18.15, find the value of I required to establish a flux in the gap of


Trades & Technology

When an evaporator coil gets dirty:

A) The temperature drop across the coil decreases. B) The static pressure drop across the coil decreases. C) The thermostatic expansion valve feeds more refrigerant to compensate. D) The static pressure drop across the coil increases.

Trades & Technology

____ default practice allows aligned decimal millimeter dimensions. Both standards are used throughout North America.

A. IEC B. ANSI C. ISO D. IETF

Trades & Technology