A complete binary tree with N nodes may be stored in an array A of length N by storing the root at A[0], and then storing in successive array locations the nodes of the tree in increasing order of the level of nodes. If nodes in the same level are stored in left to right order, then the right child of the node stored at A[k] will be stored at

A) A[k/2]
B) A[2k]
C) A[2k+1]
D) A[2k+2]


D) A[2k+2]

Computer Science & Information Technology

You might also like to view...

In this lab, you are configuring OSPF to the adjacent LAN for the network shown in Figure 1. You will be required to verify that computers in your LAN can ping the neighbor LAN. Note that a serial interface is being used to interconnect the LANs. You are configuring routing for both 172.20.15.0 and 192.168.25.0 networks. A subnet mask of 255.255.255.224 is being used. Use 56000 for the clock rate on the serial link (DCE interface). Use a subnet mask of 255.255.255.252 on the serial link connecting the two routers.

Computer IP Addresses, Subnet Masks, and Gateway Addresses


1. Configure the gateway address for FastEthernet 0/0 and the serial s0/0/0 interfaces on
Router R1. You also need to configure the IP address and the gateway address for PC-1.
Use the IP address and subnet mask specified in Table 1. You will need to enable each
interface and set the clock rate on the serial interface to 56000. List the router prompts
and commands used to configure the interfaces.
2. Configure the gateway address for FastEthernet 0/0 and the serial s0/0/1 interfaces on Router R2. Use the IP addresses and subnet masks specified in Table 1. Enable each interface and list the router prompts and commands used to configure the interfaces.
3. Configure the host name for your routers. R1 should be renamed LAN-A, and R2 should be renamed LAN-B. List the router prompts and commands used to configure the router’s host name.
4. The proper commands to verify that the interfaces on the LAN-A and LAN-B routers have b

Computer Science & Information Technology

In order to apply a style to a particular section of a document, use the ________ element

A) area B) section C) div D) paragraph

Computer Science & Information Technology

?A table is in _____ if it is in first normal form and if all fields that are not part of the primary key are functionally dependent on the entire primary key.

A. ?second normal form B. ?zeroth normal form C. ?third normal form D. ?fourth normal form

Computer Science & Information Technology

The best way to work with services is to use the _______________ applet.

Fill in the blank(s) with the appropriate word(s).

Computer Science & Information Technology