Answer the following statement(s) true (T) or false (F)
1. A perpendicularity tolerance can only constrain rotational degrees of freedom relative to the datum referenced.
2. Perpendicularity can be applied to a planar surface, but not to a feature of size.
3. Where two datum references are used with a perpendicularity tolerance, the tolerance zone is perpendicular to the primary datum reference.
4. When a perpendicularity tolerance is applied to a planar surface, the deviation is verified by finding the distance between two parallel planes that all of the points of the surface are located within.
5. A common method used to verify a perpendicularity tolerance (MMC) is to use a height gage.
1. T
2. F
3. T
4. T
5. F
You might also like to view...
Explain why a compression test alone is not a good indication of engine condition and what other test is more comprehensive.
What will be an ideal response?
Which statement describes the relationship of IL and IR in Figure 12-2?
A) IL leads IR. B) IL lags IR. C) They are 180° out of phase. D) They are in phase.
The Sylvania Super Saver 75 W light uses 20 watts, produces 1280 lumens, and costs $4.49. As an alternative a generic 75 W incandescent light bulb costs $0.40, produces 1200 lumens, and has a service life of 750 hours. Compare the performance of each light by calculating the efficacy for each light and estimate how much it would cost to run each light for 4 hours per day for 300 days in a year. Assume electricity costs 9 cents per kWh.
What will be an ideal response?
Answer the following statement(s) true (T) or false (F)
1. A design problem in general is the characterization of a societal need. 2. A design problem characterizing a societal need will have a unique solution. 3. A solution space is the collection of all possible solutions to a design problem. 4. All design problems are well defined. 5. In general the solution space to a design problem is known well.