A dimension of 50 millimeters should be shown as:

A. 50
B. 50.0
C. 50.00
D. 50.000


Answer: A

Trades & Technology

You might also like to view...

What is a down-feed potable system and where is it used?

What will be an ideal response?

Trades & Technology

Saturated liquid water at 2000 kPa enters a throttling valve at 5 m/s. The stream exits the throttling valve at 400 kPa, at a velocity of 25 m/s.

(a) Determine the quality of the exiting saturated mixture. (b) Using your model of a throttling device, plot the exit quality for the same inlet conditions and same outlet pressure, but for exit velĀ°Cities ranging from 1 m/s to 100 m/s. (a) Given: P1 = 2000 kPa; x1 = 0 (saturated liquid); V1 = 5 m/s; P2 = 400 kPa; V2 = 25 m/s Water (Take State 1 as the inlet, State 2 as the outlet.) Assume: Q?=W?=0. For a throttling valve, assume steady-state, steady-flow, single-inlet, single-outlet flow, with ?PE = 0 (we are considering the impact of changes in kinetic energy) What will be an ideal response?

Trades & Technology

Identify this alternator component.

A) Stator linkage B) Diode trio C) Alternator end housing D) Rectifier bridge

Trades & Technology

Technician A says that a battery should not be stored on a concrete floor. Technician B says that a battery will not be able to be fully charged if placed on a concrete floor when being charged. Which technician is correct?

a. Technician A only b. Technician B only c. Both Technicians A and B d. Neither Technician A nor B

Trades & Technology