A sheet metal screw holding a metal body panel has pierced the insulation of a wire and is touching the copper wire. This would cause a ____________
A) Short to power B) High resistance C) Short to ground D) None of these
C
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The tolerance zone for a flatness tolerance is the space between two perpendicular planes. 2. If a flatness tolerance is applied to a surface, the high and low points of the surface must be within the tolerance zone. 3. If the limit of the flatness deviation provided by Rule #1 is sufficient for the function of the application, there is no need to specify a flatness tolerance. 4. Where a flatness tolerance is applied to a surface that is associated with a size dimension, and Rule #1 applies to the size dimension, the flatness tolerance value must be more than the size tolerance. 5. A dial indicator, also known as a dial gage and probe indicator, is an instrument used to accurately measure small linear distances, and is frequently used in inspection of parts.
How are ultrasound machines used when evaluating hog carcasses?
What will be an ideal response?
An alternator is being tested using an oscilloscope. The following pattern is observed. What does the pattern indicate?
A) Open diode B) Loose output terminal C) A normal pattern D) Shorted diode
How is the ice removed from the evaporator of a flake ice machine?
A) The flexible mold is twisted until the ice releases. B) A slow-turning spiral-fluted auger cracks the ice off. C) A harvest cycle using hot gas bypass D) The evaporator is teflon coated so the ice slides right off.