Answer the following statement(s) true (T) or false (F)
1. The tolerance zone for a flatness tolerance is the space between two perpendicular planes.
2. If a flatness tolerance is applied to a surface, the high and low points of the surface must be within the tolerance zone.
3. If the limit of the flatness deviation provided by Rule #1 is sufficient for the function of the application, there is no need to specify a flatness tolerance.
4. Where a flatness tolerance is applied to a surface that is associated with a size dimension, and Rule #1 applies to the size dimension, the flatness tolerance value must be more than the size tolerance.
5. A dial indicator, also known as a dial gage and probe indicator, is an instrument used to accurately measure small linear distances, and is frequently used in inspection of parts.
1. F
2. R
3. R
4. F
5. T
You might also like to view...
How can you determine the power factor of a system?
What will be an ideal response?
A medication preparation area in a nursing home may have alternate power connected via a delayed automatic transfer device during a power failure in a _____.
a. Type 1 EES b. Type 2 EES c. Type 3 EES d. Type 4 EES
When an evaporator float switch is used in the drain pan of an air conditioner or heat pump, if the drain pan fills up the float will interrupt the low voltage circuit to:
A) The condensate pump. B) The compressor contactor. C) The fan relay. D) The gas valve.
The purpose of Block 4 in Figure 16-2 is to ________
A) maintain a constant output current when the load current changes B) make sure that the fuse will not blow C) adjust the output voltage to the correct ac value D) keep the dc output voltage constant as the load changes