How is the energy efficiency ratio (EER) calculated?
A) The input in watts is added to the output in Btuh.
B) The output in Btuh is divided by the input in watts.
C) The output in Btuh is multiplied by the input in watts.
D) The input in watts is divided by the output in Btuh.
B
You might also like to view...
A dual-mass flywheel is used to ________.
A) Reduce clutch effort B) Increase torque holding ability of a clutch C) Reduce vibration D) Decrease vehicle weight
Cuando se construyen pisos de concreto para varias plan- tas, por lo general el apunta- lamiento se instala debajo de las últimas _____ losas de piso que se hayan retirado más recientemente de sus sistemas de apuntalamiento.
a. una b. dos c. tres d. cuatro
The low voltage panel enclosure should be installed _____.
a. after the switch points are installed b. in the upper right hand corner of the high-voltage panel c. at eye level between two studs d. after all relays have been tested
What is the ratio and how is it expressed or labeled?
What will be an ideal response?