Technician A says that bearings should be thoroughly cleaned with solvent before repacking with grease. Technician B says that it is important to use manufacturer approved bearing grease to prevent premature bearing wear. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician


C

Trades & Technology

You might also like to view...

DC does not periodically go from plus (+) to minus (-) and does not pass through the ______________ axis.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Express 25°17'34" as decimal degrees.  Round the answer to 4 decimal places.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Given a simple circular curve with the following properties: D = 11°, bearing on incoming (back) tangent is N 89°27’25” E, bearing on outgoing (forward) tangent is S 60°10’05” E, the station of the PI = 22+69.77 Determine the following below:

(a) The intersection angle (?) (b) The radius (R) (c) The tangent (T) (d) The external distance (E) (e) The middle ordinate (M) (f) The long chord (C) (g) The length of the curve (L) (h) Station of the PC (i) Station of the PT What will be an ideal response?

Trades & Technology

At inventory time, 435 pounds of magnet wire for winding motors is available. In ten successive days, 15 pounds, 6 pounds, 24 pounds, 12 pounds, 3 pounds, 8 pounds, 17 pounds, 32 pounds, 16 pounds, and 13 pounds of wire are taken out of stock. How many pounds are left?

Fill in the blank(s) with the appropriate word(s).

Trades & Technology