In the diagram, determine lengths AB and CD to the nearest inch.
Fill in the blank(s) with the appropriate word(s).
3'10"
You might also like to view...
When an OSHA-required safety device fails during a lift, the operator is directed to _____.
a. continue until the lift is complete b. release the host reeving c. bring the operation to a safe halt d. lower the boom to a horizontal position
The GMAW process is unique in that there are _____ modes of transferring the filler metal from the wire to the weld.? ?
A. four? B. five? C. six? D. seven?
Find I? in the circuit of Fig. 11.82.
 FIGURE 1.png)
All of the following statements about brake drum measuring and condition are true EXCEPT:
A. if the highest and lowest measurements taken at any straight-line position across the drum vary by 0.006 inch or more, machine the drum to correct the problem. B. the diameter measured at the deepest groove must be 0.030 inch (0.75 mm) or more under the discard dimension. C. drums that are smooth and true but exceed the new diameter by 0.090 inch or more should be reused without turning. D. even slightly rough drum surfaces should be turned to ensure a true drum surface.