Using the rules discussed in this chapter, show the dimensions of the views shown.

What will be an ideal response?


Trades & Technology

You might also like to view...

You are making a 14" stub-up in 1" RMC and the bender deduct is listed as 10". Where do you make your first mark?

a. 1" from the end of the conduit b. 4" from the end of the conduit c. 5" from the end of the conduit d. 6" from the end of the conduit

Trades & Technology

Pipe threads are standardized by the A.N.S. A.N.S. stands for ____.

A. All Nominal Standard B. American National Standard C. All New Steel D. Apparent Nominal Standard

Trades & Technology

A low power consumption IC is the

A) CMOS. B) PTT. C) RPG. D) TTL.

Trades & Technology

Some circuits employ the use of normally open auxiliary contacts to prevent motor 2 from starting before motor 1, and motor 3 cannot start before motor2. These normally open auxiliary contacts that control the starting sequence are often called ____contacts.

A. automatic B. permissive C. energizing D. overload

Trades & Technology