Technician A says one must torque the fasteners in a specific sequence on composite panels. Technician B says electrical plungers are sometimes used in place of hard electric wires. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technicians A and B
D. Neither Technician A nor B
C. Both Technicians A and B
You might also like to view...
In response to antirevolutionary threats, radical members of the Assembly began invoking which new revolutionary principle based on mutual obligation?
a. fraternity b. legality c. equality d. liberty
What procedure is used when heating a brazed copper joint?
A) Heat the fitting first and then heat the pipe after the fitting is hot. B) Heat the pipe first and then the fitting. C) Use a fanning motion to heat the fitting evenly and slowly. D) Concentrate the flame on the line where the pipe slips into the fitting.
The controllers connected in a network can share information because they use a common set of rules known
as a _____. a. communications bus b. bridge c. single user interface d. protocol
When making a GTAW fillet weld in the horizontal (2F) position, pay close attention to the _
a. weld starts b. torch angles c. weld terminations d. percentage