Over-running clutches are designed to permit:
A. the driving force to come up to speed slowly.
B. the driving force to continue rotating if the load slows or stops.
C. the load to continue rotating if the driving force slows or stops.
D. the load to rotate opposite the driving force.
C
You might also like to view...
What is the name of the part of the joint that letter E represents in Figure 1?
a. Bevel angle
b. Groove angle
c. Land
d. Root opening
e. Bevel Face
How can dehumidification reduce the required capacity of a mechanical cooling system?
A) By precooling the air entering the evaporator B) By allowing the cooling system to be sized to meet just the sensible latent load C) By allowing the cooling system to be sized to meet just the sensible cooling load D) By reducing the air temperature through evaporation
What happens when a clutch pedal is depressed?
A) The pressure plate springs are compressed B) The release bearing is pushing against the release levers C) Both A and B D) Neither A nor B
The key to a good maintenance program begins with ____.
A. proper tool selection B. equipment and installation C. maintenance personnel training D. good record keeping