The key to a good maintenance program begins with ____.

A. proper tool selection
B. equipment and installation
C. maintenance personnel training
D. good record keeping


Answer: B

Trades & Technology

You might also like to view...

What must be done to the wafer lug butterfly valve itself just prior to installation?

a. Lubricate the shaft. b. Open the valve. c. Close the valve. d. Align the flanges.

Trades & Technology

Determine the location of the 40-kN load such that sags at points B and C in Figure P6.14 are 3 m and 2 m, respectively. Determine the maximum tension in the cable and the reactions at supports A and D.

Trades & Technology

On a dynamometer, horsepower is calculated by which of these formulae?

A) Stroke × bore × 3300 B) Stroke × bore × 55 C) Torque × RPM ÷ 5252 D) Torque × RPM

Trades & Technology

Where should the barometric damper be installed in the chimney connector?

A) Close to the furnace on the bull head of a tee that is in-line with the connector B) On the outlet of the chimney so that the vent gases must pass through it C) Close to the furnace in series with the connector so that the vent gases must pass through it D) Close to the furnace on the branch of a tee that is in-line with the connector

Trades & Technology