Answer the following statement(s) true (T) or false (F)

1. A common method for verifying a profile tolerance is to use a CMM.
2. If a profile tolerance with no datum references is applied to a surface, it will control deviations in form only.
3. A multiple single-segment feature control frame can contain as many as three segments.
4. A composite profile tolerance can only be applied to a pattern of surfaces.
5. In certain cases, a profile of a line tolerance is used as one segment in a multiple single-segment profile tolerance. In this case, the profile of a surface tolerance in the lower segment controls the size, location, and orientation of the conical surface. The profile of a line tolerance in the upper segment controls the orientation and form of the line elements (in one direction) of the conical surface.


1. T
2. T
3. F
4. T
5. F

Trades & Technology

You might also like to view...

If a 120V feeder for nonmotor loads feeds a continuous load rated at 20A and a noncontinuous load at 30A, what size overcurrent protective device should be selected?

a. 45A b. 60A c. 70A d. 80A

Trades & Technology

The design and operation of a compressor can usually be classified into two groups:

a. positive displacement and dynamic b. rotary and reciprocating c. axial and centrifugal d. piston and centrifugal

Trades & Technology

Diseconomies of scale correlate with more quantities produced than economies of scale.

Answer the following statement true (T) or false (F)

Trades & Technology

Small farm flocks of fewer than 100 head account for about what percent of U.S. sheep operations?

A. 50 B. 60 C. 75 D. 90

Trades & Technology