A standard welding symbol and weld symbols have been developed by the American Welding Society (AWS).

Answer the following statement true (T) or false (F)


True

Trades & Technology

You might also like to view...

Most nuts are high in protein and complex carbohydrates

Indicate whether the statement is true or false

Trades & Technology

?What can be done if a number of parts are made within tolerance so that the parts' overall finished size will be within its tolerance?

A. ?Make the part a little smaller so that the parts can be used. B. ?Adjust the weld joint fitup within its tolerance to compensate for the parts' tolerance. C. ?Change the design to allow the parts to be used so that the cost of new parts can be avoided. D. ?Discard the parts and start the project over with new more accurately cut parts.

Trades & Technology

The intrusion of dirt into hydraulic systems probably causes more downtime than any other single problem.

Answer the following statement true (T) or false (F)

Trades & Technology

When installing Type MC cable in a house, an anti-short bushing (red head) is required at each end to provide protection for the conductors from the sharp edges of the cable armor.

a. True b. False

Trades & Technology