Take a publicly available dataset (e.g., https://snap.stanford.edu/data/), apart from the datasets discussed in this chapter, and estimate its degree distribution, APL, and ACC, and identify whether the network demonstrates scale-free characteristics.
What will be an ideal response?
This problem is a computer-based exercise. Refer to various dataset repositories as men-
tioned in Appendix G. Further, refer to the relevant research groups as mentioned in Ap-
pendix H. Some Matlab code fractions available for simulations can be found at https:
//complexnetworksbook.github.io
You might also like to view...
While saving a worksheet as a web page, you can choose to change the ________
A) language B) formatting C) title D) values
In this lab, you are configuring OSPF to the adjacent LAN for the network shown in Figure 1. You will be required to verify that computers in your LAN can ping the neighbor LAN. Note that a serial interface is being used to interconnect the LANs. You are configuring routing for both 172.20.15.0 and 192.168.25.0 networks. A subnet mask of 255.255.255.224 is being used. Use 56000 for the clock rate on the serial link (DCE interface). Use a subnet mask of 255.255.255.252 on the serial link connecting the two routers.
Computer IP Addresses, Subnet Masks, and Gateway Addresses
1. Configure the gateway address for FastEthernet 0/0 and the serial s0/0/0 interfaces on
Router R1. You also need to configure the IP address and the gateway address for PC-1.
Use the IP address and subnet mask specified in Table 1. You will need to enable each
interface and set the clock rate on the serial interface to 56000. List the router prompts
and commands used to configure the interfaces.
2. Configure the gateway address for FastEthernet 0/0 and the serial s0/0/1 interfaces on Router R2. Use the IP addresses and subnet masks specified in Table 1. Enable each interface and list the router prompts and commands used to configure the interfaces.
3. Configure the host name for your routers. R1 should be renamed LAN-A, and R2 should be renamed LAN-B. List the router prompts and commands used to configure the router’s host name.
4. The proper commands to verify that the interfaces on the LAN-A and LAN-B routers have b
The ________ button fits the active slide to the maximum view in the Slide pane
Fill in the blank(s) with correct word
An entertainment website contains content that describes a cause, opinion, or idea.
Answer the following statement true (T) or false (F)