A purge unit ____.
A. helps to provide subcooling in the condenser
B. helps to provide superheat in the suction line
C. relieves non-condensable gases from the system to the atmosphere
D. provides capacity control
Answer: C
You might also like to view...
Some data for pure compounds W and Z is given in the table below.
Mixtures of W and Z form an azeotrope at the following conditions: P=0.46 bar, T=50 ?C, and xW=0.86. At these conditions, the liquid mixture has a molar volume of V = 80.2 cm3/mol.
A) Determine the activity coefficients ?W and ?Z for the azeotropic mixture at 50 ?C.
B) If you needed to model the azeotropic mixture using the van der Waals equation of state, what values of the parameters a and b would you use?
C) If you needed to model the azeotropic mixture at 50 ?C using the van Laar model, what values of the parameters L12 and L21 would you use?
D) If you needed to model the azeotropic mixture at 50 ?C using the Scatchard Hildebrand model, what value would you use for the solubility parameter of compound W (?W)?
E) You are asked to determine whether mixtures of these compounds form an azeotrope at 30 ?C, and if so, the P and xWof that azeotrope.You have only the information in the table and the known 50 ?C azeotrope described above. Your teammate suggests trying two models: Wilson and Scatchard-Hildebrand. Give your evaluation of the potential use of each of these two models for this problem: is it impossible to apply without more information, is it possible to apply but not likely to be very accurate, or is it a reasonable model to use? Explain.
In the circuit of Figure P2.55, the power absorbed by the 15-? resistor is 15W. Find R.
What will be an ideal response?
Add the following decimal fractions: 9.399 + 51.645 + 6.52 + 5.56 =
What will be an ideal response?
Consideration should be given to ____________________ to a connection if there is very little solder on the joint or if it is old.
Fill in the blank(s) with the appropriate word(s).