Technician A says that wheel runout on a cast spoke wheel can be eliminated only by removing the wheel rims and breaking down the tires. Technician B adjusts cast spoke wheel runout by chalk-marking high points, then loosening the lug nuts on the chalk-marked side and tightening those 180 degrees opposite. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A nor B
D. Neither A nor B
You might also like to view...
What are some required and recommended uses for ground-fault protection devices?
What will be an ideal response?
Stucco surface, made of Portland cement and sand mix, shrinks on gaining strength, introducing tensile stress in it. Therefore, it is reinforced with metal lath, when used on a (wood or steel) stud wall, to resist the tensile stress. Why is a lath not required when stucco is applied on a CMU or reinforced concrete wall?
What will be an ideal response?
Used brake fluid should be ________
A) Poured down the drain B) Disposed of properly according to State and local laws C) Mixed with and recycled with used oil D) Poured onto open ground to reduce dust
What type of antifreeze solutions may be used in ground loops?
A) any antifreeze that will extend the freezing point down to -35°F B) low toxicity C) preferably ethylene glycol D) a brightly colored antifreeze solution should be used to make it visible in ground water