Describe the design and purpose of a clock spring electrical connector.
What will be an ideal response?
The clock spring electrical connector is a conductive ribbon mounted in a plastic case. The purpose of this component is to maintain electrical contact between the air bag deployment module and the other components in the air bag system.
You might also like to view...
The PCM will purposefully pulse the fuel injectors abnormally rich and lean when running which OBD II monitor?
A. Misfire Monitor B. Comprehensive Components Monitor C. O2 Sensor Monitor D. Cylinder Imbalance Monitor
Which is a measure of service consultant efficiency?
A. The amount of time between when the technician reports additional work is needed to the time the work is approved by the customer B. Determined by comparing the additional hours recommended by the technician and the hours approved by the customer C. Both A and B are correct D. Neither A nor B correct
Corner posts are the same length as ____.
a.plates b.studs c.sills d.shoes
A mini-wind tunnel for calibrating vane or hotwire anemometers costs $3750 in 2011 when the Marshall and Swift (M&S) equipment cost index value was 1490.2. If True-Tech Instruments estimated the cost of a wind tunnel twice as large to be $10,200 in 2016, what did it expect the equipment cost index value to be, provided the equipment cost increased accordingly? The cost-capacity equation exponent is 0.89.
What will be an ideal response?