The size indicated for the diameter of ACR copper tubing is the ____.
A. inside diameter
B. outside diameter
C. wall thickness
D. None of the above.
Answer: B
You might also like to view...
Centerline steering is achieved by correctly adjusting ________
A) Caster and SAI B) Rear camber C) Rear and front toe D) SAI and included angle
Technician A says that the outer portion of the driveshaft can be used as a slide hammer to pop the inboard CV joint out of the transaxle. Technician B says that you should not hammer on the outer end of the outboard CV joint to get it out of the hub. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Technician A says that the PCV system should create a slight pressure in the crankcase at idle. Technician B says that the PCV system should create a slight vacuum in the crankcase at 2,500 RPM. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
OSHA’s Ergonomic Standard passed but was later repealed.