____________________ gases leak past the piston rings into the crankcase.

Fill in the blank(s) with the appropriate word(s).


Blowby

Trades & Technology

You might also like to view...

If a key is lost and an emergency lockout removal is authorized, _____.

a. written verification is required to indicate that the affected employee was informed of the action b. the employee is required to make up the down time c. an OSHA inspector must be called in to sign off on the incident d. the supervisor must take the affected lock out of service

Trades & Technology

A(n) ____ is made by placing the plates at an angle to each other.

A. tee joint B. outside corner joint C. butt joint D. square butt joint

Trades & Technology

Technician A says that most digital and analog (needle-type) dash gauges use variable resistance sensors. Technician B says that permanent-magnet (PM) generators produce an AC signal and are used for vehicle speed and wheel speed sensors. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

During a fuel injector pressure drop test, the difference between any two fuel injectors should not exceed?

A) 14.7 PSI B) 0.4 PSI C) 15 PSI D) 1.5 PSI

Trades & Technology