Determine the initial and final conditions on iL and v1 in Figure P5.52.


Analysis:

Before closing, the switch has been opened for a long time. Thus we have a steady-state condition, and we treat the inductors as short circuits. The values of the two resistors are equal so the current flowing through the inductors is:

Trades & Technology

You might also like to view...

Technician A says that in an electronic air suspension system with the ignition switch turned off for over 1 hour, the compressor run time is limited to 5 minutes for raise vehicle commands on the front springs. Technician B says if the brake pedal is applied when driving the car, raise vehicle commands are completed immediately. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

Of the following combination of values, ________, ________, and ________ leads to the highest risk.

A. Low financial investment; high uncertainty; low hazard B. Low financial investment; low uncertainty; low hazard C. High financial investment; high uncertainty; high hazard D. Low financial investment; high uncertainty; high hazard

Trades & Technology

Which air impact drive size is the most commonly used?

A) 1/4 inch B) 3/8 inch C) 1/2 inch D) 3/4 inch

Trades & Technology

What is the current in a parallel RLC circuit if its impedance is 0.22 M?, Q is 100 and VS = 50 V?

A) 0.227 mA B) 2.27 mA C) 22.7 mA D) 0.0227 mA

Trades & Technology