Which of the following is not a correct diameter size for a machine screw?
A. .721
B. .034
C. .018
D. .080
Answer: C
You might also like to view...
Computer analysis of a truss. The purpose of this study is to show that the magnitude of the joint displacements as well as the magnitude of the forces in members may control the proportions of structural members. For example, building codes typically specify maximum permitted displacements to ensure that excessive cracking of attached construction, such as exterior walls and windows, does not occur (Photo 1.1 in Section 1.3). A preliminary design of the truss in Figure P4.53 produces the following bar areas: members 1 through 4, 5 in. 2 , and members 5 and 6, 2 in. 2 . Also E = 29,000 kips/in. 2 . Case 1: Determine all bar forces, joint reactions, and joint displacements, assuming pin joints. Use the computer program to plot the deflected shape. Case 2: If the maximum horizontal
displacement of joint 4 is not to exceed 0.25 in., determine the minimum required area of the diagonal truss bars, members 5 and 6. For this case assume that the diagaonal members have the same areas, while all other truss members have cross-sectional area of 5 in. 2 . Round the area to the nearest whole number. Photo 1.1: Wind damage. Shortly after thermopane windows were installed in this high-rise office building, they began failing and falling out, scattering broken glass on passers-by beneath. Before the building could be occupied, the structural frame had to be stiffened and all the original glass panels had to be replaced by thicker, tempered glass—costly procedures that delayed the opening of the building for several years.
An object having a mass m and moving with a speed V has a kinetic energy, which is equal to
a. mV b. mV2 c. ½ mV2 d. ½ mV
Technician A says that some failed high voltage battery assemblies may be repaired. Technician B says that high voltage battery assemblies often are warranted for as long as 8 years or 50,000 miles. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
____ is used most frequently for underground applications--to transport water, gas, and sewage.
A. Cast iron pipe B. Steel pipe C. Stainless steel pipe D. Plastic pipe