Answer the following statement(s) true (T) or false (F)
1. The geometric characteristic symbols are a set of fourteen symbols used in the language of geometric tolerancing.
2. A flatness tolerance can control form, orientation, or location.
3. Geometric tolerances are specified on a drawing through the use of a feature control frame.
4. When specifying a datum related control, the feature control frame may have up to five compartments.
5. The method of showing an extension line between two coplanar surfaces indicates that the surfaces are a single surface.
1. T
2. F
3. T
4. T
5. F
You might also like to view...
What can be used to allow fluid flow circulation if the discharge valves or other downstream valves are closed?
A) Cavitation B) Recycle loops C) Priming D) Vibration
It is safe to disconnect an ignition module with the ignition switch on.
Answer the following statement true (T) or false (F)
Technician A says that a differential carrier thrust screw should be adjusted to the point that it just contacts the thrust block or crown gear. Technician B says that if a thrust screw was to be backed out all the way, the thrust block would drop into the carrier housing. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Wainscoting can be any material including wallpaper, sheetrock of varied textures, wood paneling, tile, stone, or masonry used to divide walls into two visual sections.
Answer the following statement true (T) or false (F)