The grade of a fastener, such as a bolt, is a measure of its ________
A) Tensile strength B) Color C) Hardness D) Finish
A
You might also like to view...
In certain cases, the function of a part may require locating and orienting a feature size at RFS. If the location and orientation of a hole are being controlled relative to the outside surfaces of the part and a tolerance of position at RFS is applied to the hole, the tolerance zone is located at the ____________________ position of the hole.
Fill in the blank(s) with the appropriate word(s).Fill in the blank(s) with the appropriate word(s).
All of the following statements are true EXCEPT:
A. shocks often fail at the same rate. B. a defective shock absorber can cause a tire to "hop." C. a leaking shock can be the result of a defective seal or from lowering a vehicle too far. D. a damaged piston rod on a Macpherson strut causes a leak. This can result from holding the rod with pliers during installation of the top nut.
Older vehicles had radiator tanks made of brass, soldered to a copper radiator core. If the fins of the core are in good condition, a restricted copper/brass radiator can be disassembled and ____________________ by a shop specializing in radiator repairs.
Fill in the blank(s) with the appropriate word(s).
The green lizard is commonly found in Central and Southern:
A) Europe B) Australia C) Africa D) North America