Geometric dimensioning controls:
A. The form of a part
B. The position of features on a part
C. The form of a part and the position of features on the part
Answer: C
You might also like to view...
Stripped wire should be inserted into the barrel of the crimper until _____.
a. the insulation butts against the forward stop b. the insulation is just inside the barrel c. 90% of the strands are inside the barrel d. the wire is visible through the inspection opening
What is the ideal temperature during the first four weeks of storage of hardwood cuttings?
A) 30-40°F B) 50-55°F C) 60-70°F D) 70°F or higher
Use the following engine dimensions to calculate the compression ratio
Bore: 3.920 in. Stroke: 3.300 in. Gasket thickness: 0.050 in. Deck height: 0.010 in. Piston dish volume: 7.8 cc Combustion chamber volume: 59.0 cc A) 9.3:1 B) 9.4:1 C) 9.1:1 D) 9.2:1
The physical and chemical characteristics of a toxic substance are described in which of the following?
A) On-line at the poison control center's website B) NISOD publications C) Safety Data Sheets D) OSHA standard 29 CFR 1910.1200