Answer the following statement(s) true (T) or false (F)
1. With the ON delay timer, the delay in contact operation begins before the timer coil has been energized, or turned ON.
2. The basic pneumatic timing relay is designed so that additional instantaneous contacts may be added.
3. When a timer uses the format used by the Allen-Bradley timer, the preset time can be programmed with any value from 0 to 16,000.
4. The retentive timer lets the timer START and STOP without resetting the accumulated value to 0.
5. When circuit requirements demand more time than is available from a single timer, two or more timers can be programmed together.
1. False
2. True
3. False
4. True
5. True
You might also like to view...
A coal-fired power-plant receives heat at a rate of 625 MW from the combustion of coal, and rejects 430 MW of heat to cooling water received from a lake. Determine the thermal efficiency of the power plant.
Given: Q?C=?430 MW; Q?H=625 MW Assume: The power plant is operating as a cyclic heat engine. What will be an ideal response?
What is the goal of specifications on the alignment of abutting pipe ends??
What will be an ideal response?
The point where one weld bead stops and another starts is referred to as a(n) _____
a. restart b. termination c. arc strike d. weld defect
Single aluminum conductors with type XHHW insulation are mounted overhead on insulators to supply an outbuilding from another building. The 120/240 V, three-wire feeder is protected at the source with a 100 A circuit breaker. The minimum size ungrounded feeder conductors permitted are ____ AWG.
A. 4 B. 6 C. 8 D. 10