When making irregular and curved cuts along the profile of a trim molding, use a _____.
a. coping saw
b. backsaw
c. dovetail saw
d. saber saw
Answer: A
You might also like to view...
PROBLEM 2.C2 Rod AB is horizontal with both ends fixed; it consists of n elements, each of which is homogeneous and of uniform cross section, and is subjected to the loading shown. The length of element i is denoted by its cross-sectional area by its modulus of elasticity by and the load applied to its right end by the magnitude of this load being assumed to be positive if is directed to the right and negative otherwise. (Note that P1 (a) Write a computer program which can be used to determine the reactions at A and B, the average normal stress in each element, and the deformation of each element. (b) Use this program to solve Probs. 2.39.
Why does the fuel pressure on a typical return type port fuel injection system increase when you snap the throttle?
A.The manifold pressure goes up, and to maintain a constant pressure drop across the injector, the fuel must increase as well.
b.As the manifold pressure goes down, the fuel pressure must increase the pressure drop across the injector,
c.None of these.
d.As the manifold pressure goes up, the fuel pressure must increase, to decrease the pressure drop across the injector.
These thin solid extension lines are used to connect between noncylindrical features, parts, and subassemblies in an exploded assembly.
a. phantom lines b. centerlines c. trails d. sight lines
Which OSI model layer is covered by the LoRa specification?
A. Layer 1 B. Layer 2 C. Layer 3 D. Layer 7