PROBLEM 2.C2 Rod AB is horizontal with both ends fixed; it consists of n elements, each of which is homogeneous and of uniform cross section, and is subjected to the loading shown. The length of element i is denoted by its cross-sectional area by its modulus of elasticity by and the load applied to its right end by the magnitude of this load being assumed to be positive if is directed to the right and negative otherwise. (Note that P1 (a) Write a computer program which can be used to determine the reactions at A and B, the average normal stress in each element, and the deformation of each element. (b) Use this program to solve Probs. 2.39.


Trades & Technology

You might also like to view...

When a cylinder cutout test is being performed on an EUI-fueled engine with the objective of identifying a dead cylinder, what happens to mean (average) PW when the EUI over the dead cylinder is cut?

A. mean PW increases B. mean PW does not change C. mean PW decreases D. engine rpm drops by approximately 17 %

Trades & Technology

Estimate the residence time of water in the oceans.

What will be an ideal response?

Trades & Technology

Determine electrical needed for the Real Estate Office in Appendix E. Using the labor rates from Problem 7-31 and the crew rate for the electrical crew from Problem 7-32 determine the cost for the electrical.

What will be an ideal response?

Trades & Technology

The metric term for pressure (psi) is

A. Kilogram (kg). B. KiloPascal (kPa). C. Liter per millimeter (Lm). D. Liter per centimeter (Lc).

Trades & Technology