The unit of inductance is the ____________________.
Fill in the blank(s) with the appropriate word(s).
henry (H)
H
henry
Trades & Technology
You might also like to view...
The view in the illustration showing a ranch door-stop molding is labeled _____.
a. B b. C c. D d. F
Trades & Technology
Most outboard CV joints are held onto the driveshaft by using a ________ at the end of the shaft
A) Snap ring B) Cap screw C) Circlip D) Any of these
Trades & Technology
A bonding company is most concerned with the work of the:
A. resident project representative. B. architect/engineer. C. owner. D. contractor. E. construction manager.
Trades & Technology
A tire used on a truck rear axle has premature wear at both wall sides of the treads. What is the most likely cause?
A. overinflation B. underinflation C. excess toe D. excess caster
Trades & Technology