In metric drawings for weldments, a millimeter dimension with a whole number and a decimal fraction is shown with a zero following the decimal fraction.

Answer the following statement true (T) or false (F)


False

Trades & Technology

You might also like to view...

This geometric tolerance is used to control the relationship of radial features to a datum axis and features that are 90 ? to a datum axis.

a. runout b. perpendicularity c. concentricity d. profile

Trades & Technology

Technician A says that diesel electric hybrid drive technology has been used in railway locomotives for several generations. Technician B says that advantages of both hydraulic and electric hybrid drive systems stem from using small bore diesel engines in much larger vehicles than a small bore engine would normally power. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

What is the SS/PBCH index?

A. The beam identity that is coded with up to 6 bits B. The beam identity that corresponds to the carrier frequency of the beam C. The identity of the beam that is derived from the NR cell's PCI D. The starting OFDM symbol number of the SS/PBCH block

Trades & Technology

The force required to deploy a typical airbag is approximately equal to the force of a vehicle hitting a wall at over ________ miles per hour

A) 15-10 B) 3-5 C) 15 D) 10

Trades & Technology