A transistor in saturation is equivalent to what condition?

A) a closed switch B) an open switch
C) a or b depending on where voltage is measured D) none of the above


A

Trades & Technology

You might also like to view...

When selecting heater elements for the overload relays, the electrician should remember that each of the relays carries only ____ of the motor current.

a. a fifth b. a quarter c. a third d. half

Trades & Technology

G90 G20 F10 X2.5 will command the machine to move parallel to the x-axis, to a point:

A. that is 2.5 inches from the current location, at a feed rate of 10 in/min B. that is 10 inches from the current location, at a feed rate of 2.5 in/min C. where x = 2.5 inches, at a feed rate of 10 in/min D. where x = 2.5 inches, at a rapid feed rate

Trades & Technology

What are section lines and what are they used for?

What will be an ideal response?

Trades & Technology

The formula for calculating the tailstock offset is: Offset = L × (D - d)/2 × L1 where L is the total length of the piece and L1 is the length of the taper. D is the large diameter and d is the small diameter. If a shaft, that is to be tapered on one end , is 8 inches long and the taper is to be 3 inches in length, the shaft diameter is 1-1/4 inches and the small end of the taper is 1 inch

diameter, the offset should be: A) 1/3 (.333 ) inch B) .250 inch C) .100 inch D) 2.3 (.666 ) in.

Trades & Technology