What is pneumatics often used for in repair shops?
What will be an ideal response?
Pneumatics is often used for operating power tools.
You might also like to view...
What is the feeder load (in VA) for three small appliance branch circuits?
a. 1,500VA b. 1,800VA c. 2,400VA d. 4,500VA
Which of the following is true of axial spray transfers using high current settings?
A. Higher currents are needed with smaller diameter wires. B. High current aids welding sheet metal because the high heat cuts through sheet metal. C. High current settings may cause the weld to be difficult to control in out-of-position welds. D. The need for higher current removes some restrictions on the process.
Tier 1 standards ________
A) May be different for cars and light trucks B) Went into effect in 1994 C) Both A and B D) Neither A nor B
A contaminated sensing wire in a MAF sensor will cause the fuel system to ________ at idle
A) Shut off B) Go rich C) Be normal D) Go lean