The civil engineer’s 10 scale is often used in mechanical drafting as a , decimal-inch scale.
a. full
b. half
c. quarter
d. double
a. full
You might also like to view...
Compared to a parallelogram steering linkage, a rack and pinion steering system has fewer what?
What will be an ideal response?
Which is an example of a value added service during the repair process?
A. The technician washes the car B. The technicians assigned to the repair has the skill to check over the vehicle for other potential problems C. The technician takes the customer to lunch D. The technician performs additional repairs that are not authorized by the customer
On the subject of racial justice, President Eisenhower
A. had demanded the integration of the armed forces as early as 1948. B. publicly endorsed the 1954 Supreme Court school-desegregation decision. C. vetoed the Civil Rights Act of 1957. D. had advised against integrating the armed forces. E. admired the Christian philosophy of Martin Luther King.
The instructions ona low-pressure switch read "cut-out is cut-in less differential." To set the switch to cut-out at 30 psig:
A) Set both the cut-in psig and differential at 20 psi. B) Set the differential at 45 psi and the cut-in at 15 psig. C) Set the cut-in at 45 psig and the differential at 15 psi. D) Set the cut-in at 45 psig and the differential at 20 psi.