Outline the typical steps in an agile development episode.
What will be an ideal response?
a. Scrutinize a user story card, perhaps consulting with an onsite expert.
b. Consult the existing group of test cases.
c. Write down the next task on the to-do list.
d. Write a test case for the things that you are trying to find out.
e. Finish and run the test case.
f. Debug the test case.
g. Move to the next test case.
h. Move to the next item on the to-do list.
i. Load the updated release and the changes.
j. Debug and fix the code.
k. Rerun until it works.
l. Release the code.
You might also like to view...
What type of HTML list will automatically place a number in front of the items?
a. numbered list b. ordered list c. unordered list d. definition list
Observe and interpret the output of the DHCP packets. You should see the followingpacket types: DHCP Discover, DHCP Offer, DHCP Request, DHCP Ack.
What will be an ideal response?
Configure a static route to the adjacent LAN, LAN-A to LAN-B. Use the IP addresses provided in Table 1. You will be asked to verify that the computers in your LAN can ping the neighbor LAN. Note that a serial interface is being used to interconnect the LANs. You are configuring routing for both 192.168.20.0 and 172.16.75.0 networks. A subnet mask of 255.255.255.0 is being used. Use 1536000 for the clock rate on the serial link (DCE interface).
Table 1 Computer IP Addresses, Subnet Masks, and Gateway Addresses
1. Configure the gateway address for your LAN routers (R1 and R2) according to the
addresses provided in Table 1. You will also need to enable the interfaces. List the commands
used to configure the IP addresses and the subnet mask for your gateway, and list
the command used to enable the interface.
2. Configure the host name for your routers; R1 should be renamed LAN-A and R2 should
be renamed LAN-B. List the router prompts and commands used to configure the
router’s host name.
3. Configure the router interface’s serial IP addresses and subnet masks according to the
addresses specified in Table 1. Use the proper command to verify that the interfaces are
properly configured. Set the clock rate on the serial interface interconnecting the two
routers to 1536000. List the prompts and the commands used to accomplish this task.
4. Configure static routes from the LAN-A router to the LAN-
What type of information is useful only within a specific time period??
A. organized B. accessible C. accurate D. timely