In what position in the crimp-on terminal must the conductor insulation be for a proper connection?
a. Outside the inspection hole
b. In the belled mouth
c. Below the inspection hole
d. Above the belled mouth
b
You might also like to view...
Which geometry is the most common and why?
What will be an ideal response?
_____, scribes, and paint markers are used to mark materials for cutting and fitting.? ?
Fill in the blank(s) with the appropriate word(s).
When checking resistance on a split-phase motor, common-to-run will be the __________ ohm reading, common-to-start will be the __________ ohm reading, and start-to-run will be the __________ ohm reading.
A. high, medium, low B. low, medium, high C. medium, low, high D. medium, high, low
The major bearing(s) used with a clutch assembly is (are) the ________
A) Release bearing that is mounted at the front of the transmission B) Pilot bearing that supports the end of the transmission input shaft C) Both A and B D) Neither A nor B