A wound DC motor is connected in both a shunt and a series configuration. Assume generic resistance and inductance parameters Ra , R f , La , L f ; let the field magnetization constant be k f and the armature constant be ka . Assume ideal energy conversion, so that ka = kT . The motor has inertia Jm and damping coefficient bm, and it is rigidly connected to an inertial load with inertia J and damping coefficient b.
a. Sketch a system-level diagram of the two configurations that illustrates both the mechanical and electrical systems.
b. Write an expression for the torque–speed curve of the motor in each configuration.
c. Write the differential equations of the motor-load system in each configuration.
d. Determine whether the differential equations of each system are linear; if one (or both) is (are) non-linear, could they be made linear with some simple assumption? Explain clearly under what conditions this would be the case.
Analysis:
You might also like to view...
A welding joint in which one flat part lies on top of another is a:
A. Butt joint B. Lap joint C. Edge joint
Which region of Europe provides most of the continent’s illegal and forced sex workers?
a. eastern Europe b. Scandinavia c. Spain and Portugal d. Belgium and Holland
Lugging an engine means ________
A) Wide-open throttle (WOT) in low gear above 25 miles per hour B) That engine speed does not increase when the throttle is opened wider C) Starting a cold engine and allowing it to idle for longer than five minutes D) Both B and C
Forty-five thousand, six hundred twelve pipe fittings have been ordered for a large project. How would you
write this number as a whole number using digits? A) 4,561 B) 4,562 C) 45,612 D) 450,612