What should you do when you need to draw circular holes in oblique pictorials?
What will be an ideal response?
When circular holes appear in an oblique pictorial sketch, as with isometric sketches, you show the partial edges of the back circle where they are visible through the hole. Once again, partial circles are visible when the object is relatively thin or when the hole has a relatively large diameter; otherwise, partial edges are not shown.
The procedure you use to determine whether a portion of the back circle edge is visible and, if so, which portion is visible follows the procedure outlined for isometric sketches. You start by locating the center of the back edge of the hole and marking off the four radial points. You then lightly sketch the bounding box that defines the circle. Finally, as needed, you sketch the visible portions of arcs within the circular hole.
You might also like to view...
Describe methods for preventing disruption to an environmentally sensitive area.
What will be an ideal response?
Which component or system can be shared in a typical AM/FM receiver?
A) mixer B) RFamplifier C) discriminator D) audio amplifier
Define planned maintenance
A) Replacing all system components on a rotating basis B) Performing maintenance and testing whenever the system quits operating correctly C) Performing maintenance and testing based on a regular schedule D) Monitoring key performance indicators and performing maintenance when these indicators show a need for maintenance
Automatic Transmissions use all of these pressures for shift control EXCEPT:
A. governor B. torque converter C. vacuum modulator D. throttle valve